: 2–111⁄49 = 2 plies of 13⁄49 x 111⁄49) of beams needed to support the combined loads from a wall, second story floor (1⁄4 of total floor joist span) Roug and various roof truss spans with a 2* soffit. • For fastening recommendations for multiple-ply GP Lam LVL members, see pages 47-48. If you are looking for span tables, design guides, install guides, product catalogues or safety data sheets then you’ve landed on the right page.
If the soffit exceeds 2*, additional design is necessary.
No more than three holes allowed per span .
Lp solidstart lvl beam … Bearing Live Load L/360 Total Load End / Int . Bearing Live Load L/360 Total Load End / Int .
Where... GP Lam ® LVL Handling & Installation • GP Lam® LVL shall not be stored in direct contact with the ground and must be protected from weather. VERSA-LAM ® laminated veneer lumber (LVL) beams and headers eliminate twisting, shrinking and splitting, and deliver flatter, quieter floors and structures.
Covers any span and every load with pin point accuracy.
h Op enin g For non-conforming situations, use FASTBeam® analysis and selection software or contact Georgia-Pacific. 4. Select the correct table for the supported floor joist condition (simple or continuous — see notes below). 3.
In that case, 4... GP Lam ® LVL Roof Hip and Valley Beams Hip beam Roof rafter Valley beam Reaction D Post not shown at Roof rafter high end for clarity . Beam depths are typically 5 1/2 inches, 7 1/4 inches, 9 1/4 inches, 11 1/4 inches, 11 7/8 inches, 14 inches, 16 inches, 18 inches, and 20 inches.
2 pine or LVL. B&D (lbs) No . • Multiple piece GP Lam LVL may not be stagger-spliced as is sometimes done with dimension lumber. Double check yourself with these span charts. Bearing Live Load L/360 Total Load End / Int . In the tables below describe the most common measurements according to local requirements for floor joists, headers and lintels. 3 . Other (more complex) load condition spans can be determined with our free Hyne Timber Design 7.5 software.
Structural ridge beam tricks of the trade structural ridge beam tricks of the trade treated glulam beams lp solidstart lvl beam header structural ridge beam tricks of the trade, Wood beam design and installation considerations weyerhaeuser user s wooden floor framing technical steico construction beamchek 2019 structural ering column beam check builders source. B&D (lbs) Longest horizontal roof rafter span (L) No .
React . Our VERSA-LAM® LVL is manufactured in either Alexandria (Lena), Louisiana in Eastern United States, or in White City, Oregon for the Western United States. LVL 2900Fb-2.0E Floor Beam Quick Reference Tables arried Span TO USE: 1.
Calculate the size needed for a beam, girder, or header made from No. A&C (lbs) Max . Bearing Live Load L/360 Total Load End / Int . (function() { Bearing Live Load L/360 Total Load End / Int . s Span Roof Trus Snow (115%) Roof Loading Rough Opening Roof Truss Span with 28 Soffit Assumed NOTES: 1 .
Available in 13⁄49 and 31⁄ 29 thicknesses (11⁄ 29 by special order), and depths from 31⁄ 29 to 249; for 31⁄ 29 thickness or other depths, contact GP for availability Available in value lengths from 248 to 488 (lengths up to 608 by special order)... GP Lam ® LVL Bearing Details • Confirm the actual required bearing is provided by a support that has adequate strength to carry the load.
LVL 2.0E Floor Beam Quick Reference Tables arried Span TO USE: 1. Bearing Live Load L/360 Total Load End / Int . This span size only applies to single floors; floors supporting additional stories or roofs require sturdier construction and use different LVL span size charts. Select the span carried on the top line.
React . 4.
2. 2. When plate material is of Southern Pine graded non-dense or of... Allowable Horizontal Holes in GP Lam ® LVL GP Lam LVL beam Minimum clear distance between holes = 2 x diameter of the larger hole . Example: A 14'-0" span beam carries 15'-0" simple span joists on each side. Table is valid for single and multiple span uniformly loaded beams only . • Bundles must be stored level and must not be opened until time of installation. • Stack and handle GP Lam LVL flatwise. Bearing across full width of beam or header is required . Any accurate calculation of beam size must take into account the tributary load area for a beam, based on its spacing and the magnitude of load being carried. Select the correct table for the supported floor joist condition (simple or continuous — see notes below). hySPAN Structural LVL is engineered for reliable performance and is available in two complementary ranges. Bearing Live Load L/360 Total Load End / Int . Choose the required center-to-center span for the beam in the Span column. Can’t find what you are looking for?
: 2–111⁄49 = 2 plies of 13⁄49 x 111⁄49) of beams needed to support the combined loads from a wall, second story floor (1⁄4 of total floor joist span) Roug and various roof truss spans with a 2* soffit.
Bearing Live Load L/360 Total Load End / Int .
Design a beam depth based on the rule of thumb for estimating the depth of manufactured beams which is to divide the span by 20.
var _Hasync= _Hasync|| []; 5 . React .
Bearing Live Load L/360 Total Load End / Int . _Hasync.push(['Histats.track_hits', '']); An MSDS is available at www.buildgp.com. Required bearing length (based on 625 psi) is 3 .09 unless the subscript + is shown .
Our VERSA-LAM ® LVL is manufactured in either Alexandria (Lena), Louisiana in Eastern United States, or in White City, Oregon for the Western United States. Reaction A Post not shown at high end for clarity .
Select the span carried by the beam across the top of the table var hs = document.createElement('script'); hs.type = 'text/javascript'; hs.async = true; Bearing Live Load L/360 Total Load End / Int . hySPAN and hySPAN+ are easy to work with using . hs.src = ('//s10.histats.com/js15_as.js');
2 .
3.
Confirmation of structural adequacy of supporting member is required . • Engineered lumber must not be installed in direct contact with concrete or masonry construction or shall be... 2.0E GP Lam ® LVL Window and Patio Door Headers, 2-Story Span A ≤ Span B for table below Two-Story Applications This table shows the size (e.g. Select the span carried by the beam across the top of the table.
Wood Beams Laminated Span Tables.